ContinuousInk.info Forum Index
RegisterSearchFAQMemberlistUsergroups|Join Groups
Knowledge BaseLinksDownloads Gallery 2CalendarLog in
 Quick Stats 
Most Popular :: Toprated Articles :: Latest Articles
 C84, C86, C88, D88 Waste ink tank modification 

Author MartinDate Fri Apr 11, 2008 11:34 amViews 12522
Description Installing an external waste ink tank for the C8x series printers
Category Printer ModificationsType How to..

Contents

Open up the printer

IMG: http://www.continuousink.info/forum/gallery2.php?g2_itemId=111
First you need to open up the right side of the printer (side nearest where the print head rests). I won't go into how you do this in details but basically there are 3 clips/retaining lugs on the outside and 2 on the inside of the case. Be careful not to break them and use a flashlight and mirror to spot where the internal ones are.

Once you've got it open, carefully locate the waste tube and tease it out gently using a pair of tweezers. (The tube is clear and green striped and should be found easily within the printer near "A"). If you're a bit of a clutz, I recommend you use a glue gun to glue the tube into the retaining clip shown as "B". This should stop you disconnecting the tube from the pump which would be very bad!
 
Goto page 1, 2, 3, 4, 5, 6, 7, 8, 9
  
Quick KB Navigation 

You cannot post new articles in this category
You cannot edit your articles in this category
You cannot delete your articles in this category
You cannot comment articles in this category
You cannot rate articles in this category
Articles need approval in this category
Article edits need approval in this category

Powered by Knowledge Base MOD, wGEric & Haplo © 2002-2005
PHPBB.com MOD
Board Security

85216 Attacks blocked