ContinuousInk.info Forum Index
RegisterSearchFAQMemberlistUsergroups|Join Groups
Knowledge BaseLinksDownloads Gallery 2CalendarLog in
 Quick Stats 
Most Popular :: Toprated Articles :: Latest Articles
 C84, C86, C88, D88 Waste ink tank modification 

Author MartinDate Fri Apr 11, 2008 11:34 amViews 12522
Description Installing an external waste ink tank for the C8x series printers
Category Printer ModificationsType How to..

Contents

Glue the mount point and Tape the tubing

IMG: http://www.continuousink.info/forum/gallery2.php?g2_itemId=125
If you haven't already done so, you should glue the original waste pipe into it's retaining clip (Shown as "F") to stop it being yanked out due to any rough handling. This is where the optional glue gun comes in handy!

I also put a small amount of electricians insulation tape around the tube join to stop small the tubes parting too easily.
 
Goto page 1, 2, 3, 4, 5, 6, 7, 8, 9
  
Quick KB Navigation 

You cannot post new articles in this category
You cannot edit your articles in this category
You cannot delete your articles in this category
You cannot comment articles in this category
You cannot rate articles in this category
Articles need approval in this category
Article edits need approval in this category

Powered by Knowledge Base MOD, wGEric & Haplo © 2002-2005
PHPBB.com MOD
Board Security

85216 Attacks blocked