ContinuousInk.info Forum Index
RegisterSearchFAQMemberlistUsergroups|Join Groups
Knowledge BaseLinksDownloads Gallery 2CalendarLog in
Reply to topic   printer-friendly view Page 1 of 1
Canon CLI 8 and BCI 3 - how to attach elbow
Author Message
Reply with quote
Post Canon CLI 8 and BCI 3 - how to attach elbow 
Does anyone have a close up pic of these cartridges? Where to put the elbow ? Is there a air vent that also needs to be plugged ?

View user's profile Send private message
Reply with quote
Post Re: Canon CLI 8 and BCI 3 - how to attach elbow 
xeroid2 wrote:
Does anyone have a close up pic of these cartridges? Where to put the elbow ? Is there a air vent that also needs to be plugged ?

If you want to put the elbow in where it won't hit the case you need to pop it over the sponged area.. Bear in mind that it needs to be far enough forward to allow the cartridge to be inserted and site under the retention bar as well..

As to the vent that's the area at the back of the cartridge and does need to be sealed.. (it looks like a bunch of worm holes under the tape.


_________________
Printers: (Canon) MP500/830, MX700, iP4000/4200/4300/4500/5200, iX4000(A3) (Epson) C84/86, D88, CX6600, R285/800/1900 (HP) K550, K850, K5400, L7680
View user's profile Send private message Send e-mail AIM Address Yahoo Messenger MSN Messenger ICQ Number
Display posts from previous:
Reply to topic   printer-friendly view Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
  


Board Security

85216 Attacks blocked